News:

Long overdue maintenance happening. See post in the top forum.

Main Menu

Best Place for an Oil Change? (Midtown)

Started by PonderInc, April 17, 2009, 04:41:27 PM

Previous topic - Next topic

nathanm

Quote from: Red Arrow on May 07, 2009, 07:57:46 AM
In the days of full serve gas stations, we had a car that I pulled in and said to fill the oil and check the gas.
I thought RM's post was pretty funny..until I read this one. It would have induced a coffee spitting incident if I was drinking some at the moment.  ;D
"Labor is prior to and independent of capital. Capital is only the fruit of labor, and could never have existed if labor had not first existed. Labor is the superior of capital, and deserves much the higher consideration" --Abraham Lincoln

sauerkraut

Quote from: Conan71 on April 30, 2009, 10:07:28 AM
Hot/cold, doesn't matter.  The issue is, pull the dipstick, wipe it clean, replace, pull it back out then read it.
Yes, but wait a few minutes after you shut off the engine before you check the oil, so the oil can drain back into the oil pan. Hot oil expands a bit so the reading could be a bit higher than checking the oil when it's stone cold.. I do my own oil changes on my heap. I have a F-150 and it takes 6 quarts with a filter change. It's faster and I know it's done right. :)
Proud Global  Warming Deiner! Earth Is Getting Colder NOT Warmer!

RecycleMichael

For all you do-it-yourselfers...

All 12 of the M.e.t. recycling centers accepts used motor oil for recycling. Our centers are open seven days a week, but we ask you to bring oil during regular business hours to avoid any potential spills.
Power is nothing till you use it.

sauerkraut

Quote from: RecycleMichael on May 07, 2009, 03:16:58 PM
For all you do-it-yourselfers...

All 12 of the M.e.t. recycling centers accepts used motor oil for recycling. Our centers are open seven days a week, but we ask you to bring oil during regular business hours to avoid any potential spills.
So does Auto Zone, Advance Auto and 'O Reilly's That's where I take mine. Many of those fast lube joints seem to over-tighten the oil drain plug and with today's aluminum oil pans that's asking for big trouble. The worker turn over rate is high.
Proud Global  Warming Deiner! Earth Is Getting Colder NOT Warmer!